Yongle UBEC 5V / 12V 3A ( 2S - 12S )

This UBEC is suited to high voltage applications. The UBEC accepts 3-12S LiPo voltage input and outputs a jumper seletable 5V / 12V continuous current of 3A with a 5A burst rating. There is a switch to manuaully turn on and off the output and an LED to indicate when it is live.

The device features a high efficiency switching DC-DC regulator, which provides better heat dissipation when compared to linear voltage regulators. Furthermore its shielded PCB design and output EMF coil help provide a stable and low noise voltage output.

- The use of imported blood pressure of the switching power supply IC design, efficiency as high as 90%.
- To ensure performance, while compact design, small size, light weight, only 25g.
- The use of low-noise design, all components fully shielded, and the use of closed magnetic power inductors, while the output lines with magnetic ring, greatly reducing the electromagnetic interference.
- Output current, continuous output current 3A, the peak output current 5A; fully guarantee the electricity demand of the device.
- With a wide range of operating voltage, can work between the 2S-12S.
- With overheat protection, output short circuit protection, output overvoltage protection and anti-reverse function.
- Output indicator, red LED work light, UBEC normal working hours, lights.
- Soft-start switch, turn on or off the output UBEC by soft start switch.
- 5V/12V switching voltage output: via jumper to choose. Jumper take pin1 and pin2 inserted two pins is 12V output select, insert two pins in pin2 and pin3 is to choose 5V output, refer to the diagram; if the jumper is lost, the UBEC default output is 5V.
- The power indicator: Power indicator is used to display the output state. It lights when the UBEC has the normal voltage output, if not light, check the power input cable is connected, the battery pack is good.
- Output ON / OFF: switch to "ON", the output open; to "OFF" position, the output is off.
- 5V for Flight Controller (FC), FPV Camera, Receiver, Servos
- 12V for FPV Camera / 5.8Ghz Video TX / LED Lighting
- Output Voltage: 5V or 12V (Changeable via jumper)
- Continuous output current: 3 Amps
- Burst output current: 5 Amps
- Input: 2 -12S Li-Po
- Size: 47mm x 26mm x 9mm
- Weight: 28g

Write a review